|
AMH-762
1/8 Din Size
3 1/2 Digit
High
Conversion Rate
(4000/sec)
|
DC Voltage Measurement
| Model |
Range |
Display Adjustable |
Input Impedance |
Input Protection |
| AMH-762-13 |
±9.999V |
Offset ±10000 Fullscale ±0~10000 |
1M ohms |
±250V |
1-5V Measurement
| Model |
Range |
Display Adjustable |
Input Impedance |
Input Protection |
| AMH-762-1V |
1-5V |
Offset ±10000 Fullscale ±0~10000 |
1M ohms |
±250V |
4-20mA Measurement
| Model |
Range |
Display Adjustable |
Input Impedance |
Input Protection |
| AMH-762-2A |
4-20mA |
Offset ±10000 Fullscale ±0~10000 |
50 ohms |
±70mV |
Ordering Code
AM-752-(Range)-(Power Supply)(Output)-(BCD
Output)(Comparator Output)
| Range |
| Power Supply |
1. 90~264VAC |
| Output |
1. none
2. BCD
3. RS-485
4. RS-232C
5. Analog Output (1~5V, 4~20mA) |
| BCD Output |
1. None
2. TTL
3. Open Collector |
| Comparator Output |
1. relay output
2. photo coupler |
Common Specifications
| Input Configurations |
Single Ended |
| Operation Method |
Successive approximation type |
| No. of Input |
A input and B input |
| Conversion Rate |
0.5 times to 4000 times (only use one
input)
0.25 times to 20000 times (uses two input) |
| Display |
LED, 10mm height (red)
8mm height (green) for monitor |
| Display Speed |
1.25, 2.5, 12.5, 25 times per second
for Normal speed mode
When pressed key of "C", appear display
value for High speed mode |
| Polarity |
A "-" is displayed
automatically |
| Overrange Indication |
When input exceeds the maximum
display, display OL and flash |
| Max Display |
±99999 |
| Decimal Point |
Settable to any digit position |
| Zero Display |
Leading zero suppression |
| External Control |
Hold: shorted D.COM and S/HA, A/HB
terminal or level "0"
Start; Open D.COM and S/HA, S/HB terminal or
"1" level
Digital Zero; Shorted D.COM and DZA, DZB terminal
or level "0"
Peak Hold:
Valley Hold: Shorted D.COM and PH terminal or level
"0"
Peak Valley Hold: (compare the display value)
selected either one
Pattern Select: combination of D.COM and P.SEL
terminal
Level "0"=0 to + 1.5V
Level "1"=+3.5 to 5V
Current = less than -5V
*Not provided PH, DZA and DZB for RS-232C and
RS-485 output |
|
