| Input Configuration |
Single Ended |
| Input Bias Current |
Less than 120PA |
| Conversion Rate |
2.5/sec |
| Normal Mode Rejection |
40dB (Typ) (50/60Hz) |
| Zero Stability |
Automatic Zero Suppression |
| Display |
LED, 8mm, 3 ½ digit |
| Polarity |
A "-" is displayed
automatically |
| Decimal Point |
Settable to any digit position |
| Overrange Indication |
When input exceeds the maximum
display, 1999 flashes |
| Control System |
Analog comparator system |
| Setting Range |
0~+1999 or -1999 |
| Comparative Condition |
Indication >/= setpoint (LED ON) |
| Relay Contact Capacity |
250V AC 0.1A Resistive load
120V AC 0.5A Resistive load
28V DC 1A Resistive load |
| External Control |
Reset; When TTL level "0"
or reset and common terminal (short) comparison value hold
Start: Contact signal (Open) |
| Hystresis |
Approx. 20 digits (23°C ± 5°C) |
| Power Supply |
DC5V ± 5% |
| Operating Temperature |
0~50°C, 35 to 85% RH |
| Power Consumption |
Approx. 500mW |
| Dimensions |
24(H) x 48(W) x 73(D)mm DIN Size |
| Weight |
Approx. 60g |
| Dielectric Strength |
Between input (Lo) terminal and relay
ouput, DC500V; Between Power Supply terminal and case, AC 1500V/1
min |
| Insulation Resistance |
DC500V 100M ohms, power supply (Lo)
and relay output |
